How to remove the unused pin from the WireTab in the foarmboad?

Suee Chi

• September 14, 2020 17:13

I have used the connectors pins by renaming its pins for grouping purposes. Since my connector has many pins left and are left unconnected, I don't want them to show in formboard or any Wiretabs ( figures not shown here now) . How can I customize those Wiretabs that it does not show unconnected pins in foarmboad? 

Please don't tell me to make a new connector with reduced pins. 

Was this Helpful?

0

• 

  Laura M

  • September 14, 2020 20:16

  Hi Suee, 

  In the Settings menu under the Formboard category, there is a setting to allow you to show only used connector pins on the formboard tables. 

  If you disable the setting Display pins without conductor, the table will only display the pins with conductors. This setting will only apply to objects that are drawn after changes have been made to the settings, and not to existing objects. Therefore, if you already have tables placed you will need to delete the tables and replace them. 

  

   

   

  Kind regards,

  Laura Mirto

  Was this Helpful?

  0
• 

  Suee Chi

  • September 16, 2020 17:26

  Thanks Laura Mirto for solving my problem. How can I make sure that it shows the pins that are graphically connected in the schematic. The connections having a core are shown but others are not shown in this scheme. 

  Kind regards,

  Suee Chi

  Was this Helpful?

  0
• 

  Laura M

  • September 23, 2020 00:05

  Hi Suee, 

  At this time, there is only a setting for displaying pins with conductors on the formboard tables. 

   

  Kind regards,

  Laura Mirto

  Was this Helpful?

  0

Please sign in to leave a comment.