Renumber Parts

Oliver Schumann

• August 24, 2020 13:05
• Edited

How can I renumber all parts of all schematic pages according to the setup page prefix?

My solution: <CTRL>+<X> and <CTRL>+<V>
But it's a little bit annoying to move everything back in place.

Was this Helpful?

0

• 

  Takashi Ichikawa

  • September 18, 2020 18:18
  • Edited

  Hello Oliver,

   

  Are you like Reference to be take the value of "Initial Value of Reference" set in the Sheet Settings?

  

   

  Then, [Design Assist] > [Reference Allocator] > [Circuit Reference Allocator] would do.

  

   

  "Only Open Component and Gate" need to be OFF, "Consider Hierarchy/Sheet Initial Value" need to be ON.

  

   

  Regards,

  Taka

  Was this Helpful?

  0

Please sign in to leave a comment.