CR-8000 Design Force “Route Center” utility

CR-8000 Design Force “Route Center” utility used to set the spacing of a group of routes to a different value than the design rule.

During the design cycle of a PCB there may be times when the designer wants to compact or spread a group of routed wires to a specified spacing other than the design rule.

Launch the “Center” Dialog in the Routing section on the Ribbon under the Track Tab.

Drag across the routes you wish to change to the new spacing.

The lines are now spaced to the specified value.

 

 

 

0

Comments

0 comments

Please sign in to leave a comment.

Didn't find what you were looking for?

New post