How to change the net of a via?
Was this Helpful?
-
Hello Pauline,
Sorry for us to late reply on this one.
For CR-5000 Board Designer, I reply to below post, so please reference on that page.
https://community.zukenusa.com/hc/en-us/community/posts/360033260834-changing-nets-on-via-holes
For CR-8000 Design Force, we can do this by following steps.
Using [Delete Net] command under [Track] tab.
If a via is still connected with component pins, we do get below message. In this case first we do need to delete all the figures(line/area) that connected to this via.
Using [Delete] command under [Home] tab.
You may want to turn ON [Select Segments/Vertices] on Status bar. This way only the selected segment of line get deleted.
Then using [Generate Net] command, first select figure(pin/line/area) with net name.
Then select a via.
Now a via gets new net name.
This way we can change the net on a via in CR-8000 Design Force.
Was this Helpful?
0
Please sign in to leave a comment.
Comments
1 comment