What can we help you with today?

Log in and chat with an Applications Engineer now! Check out our chat button in the bottom right corner!

What can we help you with today?

Log in and chat with an Applications Engineer now! Check out our chat button in the bottom right corner!

changing nets on via holes

Comments

2 comments

  • Takashi Ichikawa
    Takashi Ichikawa

    Hello Robert,

    Sorry for us to late reply on this one.

    In CR-5000 Board Designer, we can use [Edit Net] command in Placement/Wiring Tool can do this.

    Use [Delete Subnet] mode in [Edit Net] command.

    When you do make sure a via is not connected with any of component pins.  If it still connect with component pins, then we do get below picture message.

    In that case using Delete command to delete all the figures connected to a via.

    If none of other figures connected to via, then we can do [Delete Subnet] to a via.

    Next using [No Net -> Net] mode in [Edit Net] command, first select figure with net.

    In below picture I select wiring line with net name "RF_OUT".

    Next select a via.  Now via get net name "RF_OUT".

    This is how we can change the net name on via in CR-5000 Board Designer.

    Was this Helpful?

    0
  • Robert
    Robert

    Thank you!

    I really appreciate it. Will put in my “tips and tricks” folder.

    Was this Helpful?

    0

Please sign in to leave a comment.